search

Ella EW-SS-A-STD Guide d'installation Page 19

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 48
  • Table des matières
  • MARQUE LIVRES
    • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 18
www.ellasbubbles.com Page 19 0 8/14
®
www.bciacrylic.com
42
INSTALLATION / WALL SURROUNDS
Tip:
Try to measure the walls using the same increments on both sides.
Step 4: Measure from the plumbing wall to the back wall in the same 3 or 4 different locations you used to check if the wall was plumb. (Image X)
SOAP DISH WALL INSTALLATIONCONTINUED
Step 5: Write all of your measurements on your notepad. Transfer your measurements to your new wall panel and, using a straight edge, draw lines con-
necting the marks. (Image Y)
Tip:
When your project includes simulated tile walls, you will need to take some additional time to pre-plan before cutting to ensure
your grout lines will match up on all three panels. This can be done by taking accurate measurements of your soap dish wall and preliminary
measurements of your plumbing and back walls. You always want to be sure the full tile is at the top, and equal spacing of tiles are on the left
and right.
2
2
2
72
/
72
/
72
1
/
4
2
2
2
52
/
X Y
Step 6: Cut the wall panel slowly, carefully support the panel with your other hand and keeping your ngers clear from the blade. Clean up scraps as you
go. (Image Z)
Step 7: Test t the panel and mark necessary adjustments. (Image AA) Use suction cups to assist in handling the panel during the test t and installation.
Tip:
Be real careful with larger panels while walking through the customers’ home.
Step 8: Continue to measure, trim and test t until you have a desired t.
Step 9: Wipe down the existing wall with denatured alcohol. Tap any excess primer off your brush and into the can so it does not drip, then apply it around
the perimeter, staying ½” away from the edge, and from side to side in lines approximately 5 to 9 inches apart.
Tip:
If using simulated tile, the suction cups will not adhere to the panel. Instead, you can pull down a section of the plastic slip sheeting to
create handles and use those to help put the wall in place. (Image BB)
Z AA BB
SOAP DISH WALL INSTALLATIONCONTINUED
SOAP DISH WALL — LEVEL MEASURE OPTION CONTINUED
INSTALLATION / WALL SURROUNDS
Wall Surrounds
Vue de la page 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Commentaires sur ces manuels

Pas de commentaire
  • Acoustical Solutions CoolIT Feiyue Mettler Electronics DMTech
  • Cisco Routeurs Braun Produits d'entretien du corps et de rasage Agilent Technologies Générateurs d'électricité CITROEN Voitures Powermate Non
  • Sony DCR-HC85E Sony KD-49XF8096 Sony PS-J11 DeWalt GX390 KitchenAid KMMGX 45600
  • Eminent Ewent EW3966 Manuel de l'utilisateur Aphex 141 Manuel de l'utilisateur Siemens SCD 1297 Manuel de service Acer KA240H Manuel de l'utilisateur Pioneer P1 Manuel de l'utilisateur