Ella EW-SS-A-STD Guide d'installation télécharger pdf (Page 20)

www.ellasbubbles.com Page 20 0 8/14

www.bciacrylic.com

INSTALLATION / WALL SURROUNDS

Step 10: Make sure the primer is dry to the touch and apply the butyl tape on top of the primed areas. Press rmly when installing so the butyl tape does

not pull up when you remove the release paper.

(Image CC)

Step 11: Remove the release paper. Apply the silicone in between the butyl tape in a “Z” pattern, keeping the bead about ¼” thick. (Image DD)

Step 12: Clean the back of the new panel with denatured alcohol or damp cloth. Press the panel rmly into place. (Image EE) Remove the slip sheeting and

wipe down the panel to ensure it is secured.

CC DD EE

BULLNOSE EDGE FINISHES

There are three options for nishing the ends of your side walls—Option 1: the bullnose edge; Option 2: the use of a tri-guard

under the wall panel; or Option 3: the use of a tri-guard over the wall panel.

SOAP DISH WALL INSTALLATION CONTINUED

PLUMBING WALL INSTALLATION

Tip:

If you notice extensive damage to the corner bead, mud and sand the wall.

OPTION 1 - Bullnose Edge (Image FF)

Step 1: If the tile extends to the end of the wall, you will need to remove the last row of tile. Place a drop cloth over the oor and existing tub or shower base.

Step 2: Score along the edge of the tile to prevent damage to the existing wall and remaining tiles.

(Image GG)

Step 3: Break out the rst row of tile with a hammer and small pry bar. (Image HH)

Side Wall Panal

Bathroom Wall

FF GG HH

Step 4: The bullnose edge will be cut during the cutting step of plumbing wall installation.

INSTALLATION / WALL SURROUNDS

Add the existing tile thickness measure to the ¼”, previously mentioned, that allows for an 1/8” of acrylic or wall material and 1/8”

of tape and adhesive. (If the tile is 3/8” thick, the bullnose edge would be cut at 5/8”.)

Wall Surrounds

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Ella EW-SS-A-STD Guide d'installation Page 20

Commentaires sur ces manuels