Ella EW-SS-A-STD Guide d'installation télécharger pdf (Page 30)

www.ellasbubbles.com Page 30 08/14

www.bciacrylic.com

INSTALLATION / WAINSCOTING

TOOLS

o Tin Snips

o Tape Measure

o Straight Edge

o Orbital Jigsaw

o Sharpie

Marker

WAINSCOTING INSTALLATION

Step 1: Ask the customer how high up the wall they want the wainscoting to end. (Image A)

Tip:

Height cannot pass 59”.

A B C

Step 2: Draw a level horizontal line across the wall 1” below the desired location.

(Image B)

Tip:

If there is existing tile on the wall, and the top of the existing tile is level, you can use that as your horizontal line.

Step 3: Measure down from the horizontal line to the oor in 3 or 4 different locations. Add 1” to the measurements.

(Image C) Record the measurements.

Step 4: Draw a level vertical line from your horizontal line to the oor. Measure from the vertical line to one end of the wall in 3 or 4 different locations.

Record the measurements.

(Image D)

Step 5: Cut the panel, carefully supporting the panel with your other hand while keeping your ngers clear from the blade. Keep slip sheet on to prevent

any scrapes or scratches.

Step 6: Test t the panel, and make necessary adjustments.

Step 7: Prime along the border of the existing wall, staying

½” away from the edge. Place primer in vertical lines approximately 9” apart. (Image E)

Step 8: Allow primer to dry. Cover the primer with butyl tape and remove the release paper. Place silicone sealant between the lines in a “Z” pattern. (Image F)

D E F

Wainscoting

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Ella EW-SS-A-STD Guide d'installation Page 30

Commentaires sur ces manuels