Ella EW-SS-A-STD Guide d'installation télécharger pdf (Page 28)

www.ellasbubbles.com Page 28 08/14

www.bciacrylic.com

Step 4: Wipe down the existing wall with denatured alcohol. Tap any excess primer off your brush and into the can so it does not drip, then apply it around

the perimeter and from side to side in lines approximately 5 to 9 inches apart. Keep primer

½“ away from the edge. (Image DD)

Step 5: Make sure the primer is dry to the touch and apply the butyl tape on top of the primed areas. Be sure to press rmly when installing so the butyl

tape does not pull up when you remove the release paper.

Step 6: Remove the release paper from the butyl tape. Apply the silicone in between the butyl tape in a “Z” pattern, keeping the bead about

¼” thick. (Image EE)

Step 7: Clean the back of the new panel with denatured alcohol or damp cloth. Press the panel rmly into place. Remove the slip sheeting and wipe down

the panel to ensure it is secured.

(Image FF)

AA BB CC

Step 1: Transfer your measurements onto the new sheet of acrylic.

(Image AA) Use a straight edge to connect the measurements.

Tip:

If you are using simulated tile, double check that the grout lines will match up.

Step 2: Cut the panel slowly, carefully supporting your panel with your other hand and keeping your ngers clear from the blade. (Image BB)

Step 3: Test t your panel and trim as needed. (Image CC)

DD EE FF

BACK WALL INSTALLATION CONTINUED

INSTALLATION / WALL SURROUNDS

Wall Surrounds

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Ella EW-SS-A-STD Guide d'installation Page 28

Commentaires sur ces manuels