Ella EW-SS-A-STD Guide d'installation télécharger pdf (Page 26)

www.ellasbubbles.com Page 26 0 8/14

www.bciacrylic.com

INSTALLATION / WALL SURROUNDS

BACK WALL INSTALLATION CONTINUED

Step 5: Mark these measurements on your wall panel and connect the marks using a straight edge. (Image M)

Step 6: Place the wall template onto the new wall panel, ush with the top ceiling edge. Hold the template up to this depth line to mark the top and bottom

angles of the back wall. Remove the template and connect the marks using a straight edge.

(Image N)

Step 7: Mark the bullnose edge using the bullnose line guide. Locate the appropriate measurement for your bullnose edge. Place your Sharpie

marker

into the appropriate hole and slide the bullnose line guide along the bullnose edge.

M N O

BACK WALL —TEMPLATE MEASURE CONTINUED

BACK WALL – LEVEL MEASURE

Step 1: Draw a level horizontal line across the back wall, from soap dish wall to outside edge of back wall. (Image P)

Step 2: Measure from the horizontal line up to the ceiling in three different locations to determine if the ceiling is level. Record the measurements on the

existing wall.

(Image Q)

Step 3: Measure from the top of the tub or shower base up to your horizontal level line in 3 different locations. Add these measurements to your measure-

ments from the level line to the ceiling, and record them on the existing wall.

(Image R)

There are two measuring options: the template method and the level method. The following is the level method. Please refer to page 44

for the back wall template method.

P Q R

INSTALLATION / WALL SURROUNDS

Note: If your ceiling is not level, cut the top edge of the wall panel according to the difference in your measurements.

Wall Surrounds

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Ella EW-SS-A-STD Guide d'installation Page 26

Commentaires sur ces manuels