Ella EW-SS-A-STD Guide d'installation Page 22

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 48
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 21
www.ellasbubbles.com Page 22 0 8/14
®
www.bciacrylic.com
45
INSTALLATION / WALL SURROUNDS
PLUMBING WALL INSTALLATIONCONTINUED
PLUMBING WALL — TEMPLATE MEASURE OPTION
Step 1: Using the large wall template, place the template on the plumbing wall, with the long edge against the soap dish wall and the short sides tight
against the ceiling and top of tub or shower base.
(Image OO)
Step 2: Check for any gaps due to bowed walls or other miscellaneous reasons, and adjust accordingly. Once you have set the angles, tighten the lock-
knobs and remove the template.
There are two measuring options: the template method and the level method. The following is the template method. Please refer to
page 42 for level method.
OO
PP
QQ
Tip:
Be extremely careful not to bump the template once you’ve set your angles. If you do, you will need to go back and re-template.
Step 3: Measure from the soap dish wall side out to the location where the bullnose edge or tri-guard will end. In most cases, this location should be at
least
¼” past the end of the existing tile. (Image PP)
Step 4: Make sure that plumbing wall bullnose edge matches up to the bullnose edge on the ceiling.
Step 5: Mark these measurements on your wall panel and connect the marks using a straight edge.
(Image QQ)
Step 6: Place the wall template onto the new wall panel, ush with the top ceiling edge. Hold the template up to this depth line to mark the top and bottom
angles of the plumbing wall. Remove the template and connect the marks using a straight edge.
(Image RR)
Step 7: Mark the bullnose edge using the bullnose line guide. Locate the appropriate measurement for your bullnose edge. Place your Sharpie
®
marker
into the appropriate hole and slide the bullnose line guide along the bullnose edge.
(Image SS)
RR
SS
INSTALLATION / WALL SURROUNDS
Wall Surrounds
Vue de la page 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

Commentaires sur ces manuels

Pas de commentaire